High quality slow air cutoff valve kit for the 1975 to 1979 GL1000 that replaces OEM 16048-371-004 which is now obsolete. It includes the parts necessary for a complete rebuild i.e. diaphragm, spring and O-ring. Replacing your air cutoff valve will improve starting, warm up, idling and acceleration of your motorcycle.
NOTE: The GL1000 requires one (1) air cutoff valve. This price is for a single kit.,/p>
To further insure against any additional vacuum loss, replace your inexpensive carburetor manifold o-rings 82-610. Vacuum loss can occur there and mimic the effect of a bad air cut-off valve.
Over time, air cut off valves will harden up, perforate and/or disintegrate leaving your bike in a permanently lean, low RPM range (0-2200). When this occurs, your bike will progressively require excessive choking on warm-up and will miss during idling, miss and backfire when throttling up or down, and/or hesitate and backfire when trying to accelerate quickly. This condition will eventually cause "after burn" generated by a lean fuel mixture when closing the throttle.
An alternative to purchasing the costly OE assembly is our
inexpensive air cutoff valve kit and, at the same time, replace your
inexpensive carburetor manifold o-rings to insure against any additional
vacuum loss.Click here
for even more information on Air Cut Off Valves.