93-950

GL1200 FORK BRACE COVER

DISCLAIMER

THIS COVER IS NOT INTENDED FOR USE WITH THE STOCK GL1200 FORK BRIDGE. IT IS ONLY FOR USE WITH A SO-CALLED "SUPER-BRACE" OR SIMILAR FLAT TOP DESIGN FORK BRACE.

ALSO, IF YOU HAVE ANY TYPE OF FORK CHAPS YOU WILL HAVE TO MAKE ANY NECESSARY MODIFICATIONS TO SUIT YOUR INDIVIDUAL FITTING REQUIREMENTS.

1. Place the motorcycle on its center stand, and remove the "Superbrace" or similar flat top fork brace.

2. Place part 93-950 Fork Brace Cover over the brace and mark for the two holes to be drilled, and then drill two #21 holes into the brace about 1" deep, followed by tapping to size #10-32.

3. Re-install the brace(double checking for tightness), using double side adhesive stick between the cover and and brace, then securing the cover to the brace with two #10-32 screws.

We do not supply screws, which are commonly available at "ACE" hardware or Fastenal stores, or similar, in many different material grades.

Double stick tape patches are also available at many outlets.